Information for Blue Wonder™ Gun Cleaners
Blue Wonder™ Gun Cleaner is a powerful rust breaker. Use the non-toxic, biodegradable gun cleaning gel with the instructions below to quickly remove rust from the surface of your guns without harming the bluing.
Apply Blue Wonder™ Gun Cleaner to rusted areas and work in with “0000” steel wool or a brass brush until the rust is loosened. Rub the surface lightly. (This will not harm the bluing!) For heavier rust, work gel in and let sit for 5 -10 minutes. Wipe areas with a clean, dry cloth and apply Blue Wonder™ XFR premium lubricant to prevent further rusting.
For bare metal areas where harming the bluing is not a concern, Blue Wonder™ Gun Cleaner may be applied with more abrasive products such as ScotchBrite™ abrasive pads, more coarse steel wool, steel brushes, etc. (Use caution as these type abrasive materials will affect the surface finish of the metal and strip any existing bluing).
To deep clean rust from the pores of metal, first, clean the areas following above instructions. Then, apply another coat of Blue Wonder™ Gun Cleaner to the areas and while the gel is on the metal, use a propane torch and heat the areas to about 130 degrees Farenheit. (NOTE: Remove or protect wood, plastic or composite components!) Heating the metal while the gel is on it draws rust particles and residue out of the pores. While still hot, work the areas further with steel wool or brush and wipe clean with a dry cloth. Apply Blue Wonder™ XFR premium lubricant to prevent further rusting.
Blue Wonder™ Gun Cleaner may well be the strongest bore cleaner on the market. Take a gun you think is already clean and apply the gun cleaning gel with the instructions below. You will be shocked at what you get out!
1. Apply a liberal amount of Blue Wonder™ Gun Cleaner to a brass gun brush of the proper size. Run back and forth through the bore 5-6 times and then repeat. Blue Wonder™ Gun Cleaner works by "chemical reaction", so let the gel remain on the surface for 5 - 10 minutes - or longer for bores with heavy deposits.
2. After 5 - 10 minutes, run the brush back and forth through the bore 5-6 more times and then run patches until they come out dry. For a cleaner bore, wad up a piece of toilet paper or paper towel so it fits tightly in the bore and push it through with the cleaning rod. This cleans the bore better than loose patches as the paper forces itself into the lands and grooves. Repeat this until they come out dry. If still dirty after 2-3 times, repeat step 1 above.
3. IMPORTANT!! After using Blue Wonder™ Gun Cleaner, the surface will be chemically clean and free from all copper, lead, powder, etc! It is VERY IMPORTANT to finish by applying a coat of quality gun oil to prevent rusting.
For bores with very heavy deposits follow step 1 above and then plug one end of barrel with cork or similar object. From open end, fill bore with Blue Wonder™ Gun Cleaner, plug other end. Let stand overnight and then remove plugs and continue with steps 2 & 3 above.
Imagine... A Mirror Clean Bore! That's exactly what you get with